P LASMA M ONITOR † 17ConnectionsConnections with Equipment that has a Digital InterfaceConnections can be made with equipment that is equipped with a digital interface compliant with the DVI (Digital Visual Interface) standard.If you wish to input wide signals, make the “RGB MODE” and “INPUT MODE” settings.(See “Signal Identification For Raster Preset” on page 64.)Connect the Plasma Monitor to a Computer with a Digital Output• To connect the RGB 3 IN connector on the plasma monitor, use a DVI 29-pin signal cable (available separately).• The RGB 3 IN connector also accepts a DVI 25-pin (digital only) cable.• Input TMDS signals conforming to DVI standards.• To maintain display quality, use a cable with a quality prescribed by DVI standards that is within 5 meters (6.6 feet) in length.• Attach the supplied small ferrite cores to the DVI signal cable. See page 50 for attaching the ferrite cores.• The AUDIO IN 1 and 2 (both RCA) can be both used for audio input. For connection, select [INPUT 1] or [INPUT 2] from the SOUNDmenu.AUDIO OUTL RAUDIO IN 2L(MONO) RVIDEOOUTS-VIDEO VIDEOAUDIO IN 1EXTERNAL CONTROLRGB 1L(MONO) RININ OUTINOUTINRGB 2 /DVD /HDG/ Y B/ CB/ PB H/ CS VR/ CR/ PR REMOTERGB 3 AC ININ OUTC/ LINTo audio right outputTo audio left output Plasma monitorRCARCADVI connectorFerrite coreFerrite coreDVI connectorTo digital RGB outputEquipment with a digital interface such as apersonal computer with RGB output (TMDS)