E-16 †PLASMA M ONITORConnectionsConnecting Your DVD PlayerConnecting your DVD player to your Plasma monitor will enable you to display your DVD' s video.Refer to your DVD player owner's manual for more information.* When a video filmed in frames per second (progressive) is played back, the plasma monitor takes the second and third frames, andconverts them into a progressive signal with 60 frames per second. Note that only NTSC and 480i at 60 Hz is available.Connect the Plasma Monitor to a DVD Player• To connect the RGB 2/DVD/HD IN connector (BNC) on the plasma monitor, use a separately available BNC connector cable. You willneed a separately available BNC-to-RCA adapter to connect a DVD player with an RCA pin jack to the BNC connector cable.Some DVD players may have different connectors such as Y,Cb/Pb, and Cr/Pr.Select [DVD/HD] for RGB 2 from the INPUT SELECT menu.When connecting one or more Plasma monitors, use the RGB 2/DVD/HD OUT connectors (BNC).• The AUDIO IN 1 and 2 (both RCA) can be both used for audio input. For connection, select [INPUT 1] or [INPUT 2] from the SOUNDmenu.AUDIO OUTL RAUDIO IN 2L(MONO) RVIDEOOUTS-VIDEO VIDEOAUDIO IN 1EXTERNAL CONTROLRGB 1L(MONO) RININ OUTINOUTINRGB 2 /DVD /HDG/ Y B/ CB/ PB H/ CS VR/ CR/ PR REMOTERGB 3 AC ININ OUTC/ LINPlasma monitorPlasma monitor (second monitor)BNC X3BNC X3BNC X3RCABNC X3BNC-to-RCA adapterTo audio right outputTo audio left output To DVD Component video outputTo RGB 2/DVD/HD INDVD player