Program 22 : Incoming Call Setup22-11 : DID Translation Number ConversionLevel:SADescriptionUse Program 22-11 : DID Translation Number Conversion to specify for each Translation Tableentry (800).• The digits received by the system (eight maximum)• The extension the system dials after translation (36 digits maximum)• The name that should show on the dialed extension display when it rings (12 characters maximum)• The Transfer Target - 1 and 2If the Transfer Targets are busy or receive no answer, those calls are transferred to the final transferdestination (Program 22-10).• Operation ModeUse the following chart when entering and editing text for names. Press the key once for the firstcharacter, twice for the second character, etc. For example, to enter a C, press 2 three times.Key for Entering NamesWhen entering names in the procedures below, refer to this chart. Names can have up to 12 digits.Use this keypad digit ... When you want to ...1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 02 Enter characters: A-C, a-c, 2.3 Enter characters: D-F, d-f, 3.4 Enter characters: G-I, g-i, 4.5 Enter characters: J-L, j-l, 5.6 Enter characters: M-O, m-o, 6.7 Enter characters: P-S, p-s, 7.8 Enter characters: T-V, t-v, 8.9 Enter characters: W-Z, w-z, 9.0 Enter characters: 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В* Enter characters: * + , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £# # = Accepts an entry (only required if two letters on the same key are needed - ex :TOM). Pressing # again = Space. (In system programming mode, use the right ar-row soft key instead to accept and/or add a space.)Clear/Back Clear the character entry one character at a time.Flash Clear all the entries from the point of the flashing cursor and to the right.Input DataConversion Table Number 001 ~ 800SL1100 ISSUE 6.02-268 Program 22 : Incoming Call SetupProgram22
