NEC SL2100 Getting Started Manual

Also see for UNIVERGE SL2100: User guide Quick install guide User guide Installation manual Programming manual

Contents

NEC SL2100 Getting Started Manual Manual pdf 49 page image

SL2100 GETTING STARTED GUIDE45Section 6 Starting Up the SL2100 system6.1 Before starting up the systemBefore starting up the system, make sure:• Chassis are installed correctly.• All extensions are cabled correctly.• All earth ground and PSTN trunks are cabled correctly.• All boards are configured, equipped and secured correctly.• AC power cord is cabled correctly.• At least one display type multiline telephone is connected to the system. (for programming)• The Lithium battery is installed on the CPU-C1 board correctly.6.2 Plug the AC power cordThe AC power inlet is located at the back side of each chassis. The AC power cord is connected tothe AC inlet and the commercial AC power socket.!! Before connecting the AC power cord, make sure:• The power switch at the left side of each chassis is turned OFF.• The power switch at the commercial AC power socket is turned OFF.• The AC plug fits the commercial AC power socket. The plug adapter is necessary if itdoes not fit.6.3 Starting Up the SystemThere are two methods for startup (COLD Start and HOT Start).Start Up Method Description PurposeCOLD Start The factory setting data is loaded. ･First time start up･System InitializationHOT Start The customer setting data is loaded. ･System Reboot6.4 Perform a COLD StartThis section describes the process for starting the system for the first time or starting a system thatrequires the customer data be deleted.!! System software is loaded from flash memory, and the customer data is deleted fromRAM memory.