NEC SL2100 Getting Started Manual

Also see for UNIVERGE SL2100: User guide Quick install guide User guide Installation manual Programming manual

Contents

NEC SL2100 Getting Started Manual Manual pdf 65 page image

SL2100 GETTING STARTED GUIDE612.10.2 Program 14-07-01This program allows you give each exchange line the access properties for the TAM number. Each exchangeline (CO1, CO2, CO3, and CO4) have full access (property type 7) for TAM number 1. Each telephone canaccess any of the trunks.2.10.2.1 Default SettingEach exchange line (CO1, CO2, CO3) has full access (Property type 7) for TAM number 1. Thereforeevery telephone can access any of the trunks.No. Operation Display Shows;1 Log into Programming Mode.If you have already logged into Programming Mode, skip thisoperation.2 Dial 14 07 01. Enter the TAM Number and press DND key toSelect Trunk number (001-128) and step to the Next option.3 Enter the Access Property Number (0-7) for each trunk, you canoverwrite the current entry.0 – No access1 – Outgoing only2 – Incoming only3 – Retrieve held call only4 – Outgoing and retrieve held call5 – Incoming and retrieve held call6 – Incoming and outgoing7 – Incoming, outgoing and retrieve held call4 Press Hold key to confirm the entry and step to the next option.5 When you are done, press Mute key several times to return toProgramming Mode.6 Press Speaker key to save changes and exit if you are finished.2.10.3 Configuration sheet: Outgoing Excahnge Line AccessUse following table to record the outgoing exchange line access.Give each telephone a TAM number.PRG 15-06-01 TAM Number for each day/night modeDefault=TAM1 for all modesTelephone 1 2 3 4 5 6 7 8101102103104105106107108There are 128 TAM numbers available._______________________________Program Mode________Base_Service_OP1__OP2__14-07-01 Access Map1TRK 001 = 7: Full access |2← - + →14-07-01 Access Map1TRK 001 = 7: Full access |2← - + →