NEC SL2100 Getting Started Manual
Also see for UNIVERGE SL2100: User guideQuick install guideUser guideInstallation manualProgramming manual
                                                                              | |
Contents
| 
SL2100 GETTING STARTED GUIDE62Give each exchange line the access properties for the TAM number.PRG 14-07-01 Values available:0 – No access1 – Outgoing only2 – Incoming only3 – Retrieve held call only4 – Outgoing and retrieve held call5 – Incoming and retrieve held call6 – Incoming and outgoing7 – Incoming, outgoing and retrieve held callTAMNumberTrunk 1 Trunk 2 Trunk 3 Trunk 41 7 7 7 72 0 0 0 03 0 0 0 04 0 0 0 05 0 0 0 0Although there are 128 TAM numbers available, only five are listed as this is normally sufficient.2.11 Caller IDYou will need to enable this setting if: You have Caller ID service supplied on your outside lines. You have Analog telephones that are Caller ID compatible.The SL2100 can detect the Caller ID and display it on the LCD display of the SL2100 system phones.It can also be available at a Analog phone that is Caller ID compatible.You will need turn on the Caller ID detection for each trunk where it will be received. You will also need to turn onCaller ID for each of the analog telephones that are Caller ID compatible.2.11.1 Program 14-02-10, Program 15-03-09Turn on Caller ID for each Analog trunk.2.11.1.1 Default SettingThe default for Caller ID is 1 (on for each trunk).No. Operation Display Shows;1 Log into Programming Mode.If you have already logged into Programming Mode, skip thisoperation.2 Dial 14 02 10. For each trunk, enter 1 to turn on Caller ID. You canoverwrite the current entry and press Hold key to confirm the entryand step to the next option.3 When you are done, press Mute key several times to return toProgramming Mode.4 Dial 15 03 09. For each telephone, enter 1 to turn on Caller ID. Youcan overwrite the current entry and press Hold key to confirm theentry and step to the next telephone.5 When you are done, press Mute key several times to return toProgramming Mode.6 Press Speaker key to save changes and exit if you are finished.2.11.2 Configuration sheet: Caller IDWith defaults shown.Turn on the Caller ID for each trunk._______________________________Program Mode________Base_Service_OP1__OP2__14-02-10 Trunk1Caller ID 0:No← - + →15-03-09 TEL101Ext No Display 0:Off← - + → |
Related manuals for NEC UNIVERGE SL2100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine