When you want to ... Telephone ProgrammingChange Program Number Soft Key3Change Index NumberMove Cursor to Right Cursor Key (Right)Soft Key4SECTION 6 PROGRAMMING NAMES AND TEXT MESSAGESSeveral programs (e.g., Program 20-16 : Selectable Display Messages) require you to enter text. Usethe following chart when entering and editing text. When using the keypad digits, press the key oncefor the first character, twice for the second character, etc. For example, to enter a C, press the key 2three times. Press the key six times to display the lower case letter. The name can be up to 12 digitslong.Table 5-3 Keys for Entering NamesUse this keypad digit ... When you want to ...1 Enter characters : 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 02 Enter characters : A-C, a-c, 2.3 Enter characters : D-F, d-f, 3.4 Enter characters : G-I, g-i, 4.5 Enter characters : J-L, j-l, 5.6 Enter characters : M-O, m-o, 6.7 Enter characters : P-S, p-s, 7.8 Enter characters : T-V, t-v, 8.9 Enter characters : W-Z, w-z, 9.0 Enter characters : 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В* Enter characters : * + , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £# # = Accepts an entry (only required if two letters on the same key are needed - ex : TOM).Pressing # again = Space. (In system programming mode, use the right arrow Softkey in-stead to accept and/or add a space.)Clear/Back or DND/CONF (4WHybrid Multiline Terminal) / DND(IP Multiline Terminal)Clear the character entry one character at a time.Flash Clear all the entries from the point of the flashing cursor and to the right.SECTION 7 USING SOFTKEYS FOR PROGRAMMING(This Feature is available for IP Multiline Terminal Only.)Each Display telephone with Softkeys provides interactive Softkeys for intuitive feature access. Theoptions for these keys will automatically change depending on where you are in the systemprogramming. Simply press the Softkey located below the option you wish and the display will changeaccordingly.ISSUE 1.0 SL2100Networking Manual 5-5
