E-14To connect SCART output (RGB)Before connections: An exclusive SCART adapter (ADP-SC1) and acommercially available SCART cable are required for this connection.NOTE: Audio signal is not available for this connection.RGB INVideo equipmentsuch as DVD playerProjectorADP-SC1Commercially availableSCART cableFemale1. Turn off the power to the projector and your video equipment.2. Use the NEC ADP-SC1 SCART adapter and a commercially avail-able SCART cable to connect the RGB input of your projector and aSCART output (RGB) of your video equipment.3. Turn on the power to the projector and your video equipment.4. Use the RGB button on the remote control to select the RGB input.5. Press the MENU button on the remote control to display the menu.6. From the menu, select [Advanced] →[Signal Select RGB] →[Scart].SCART is a standard European audio-visual connector for TVs, VCRsand DVD players. It is also referred to as Euro-connector.NOTE: The ADP-SC1 SCART adapter is obtainable from your NEC dealer in Eu-rope. Contact your NEC dealer in Europe for more information.To RGB INConnecting an External MonitorYou can connect a separate, external monitor to your projector to simul-taneously view on a monitor the RGB analog image you're projecting.To do so:1. Turn off the power to your projector, monitor and computer.2. Use a 15-pin cable to connect your monitor to the RGB OUT (Mini D-Sub 15 pin) connector on your projector.3. Turn on the projector, monitor and the computer.NOTE:• The RGB OUT connector outputs RGB signal during standby mode. When theprojector goes into standby mode, the image on an external monitor disap-pears for a moment.• When the projector is in the standby mode, the image may not be correctlydisplayed while the cooling fans are running immediately after turning on oroff the power.• Daisy chain connection is not possible.PHONELINE INAudio cable (not supplied)RGB signal cable (not supplied)RGB signal cable (supplied)