|
E-28Selecting Signal Format [Signal Select]Allows you to choose “RGB” for an RGB source such as a computer,or “Component” for a component video source such as a DVD player.Normally select “RGB/Component” and the projector automaticallydetects a component signal. However there may be some compo-nent signals that the projector is unable to detect. If this is the case,select “Component”. Select “Scart” for the European Scart.This feature enables you to select composite video standards manu-ally. Normally select “Auto”.When you select the video standard for Video and S-Video, selectthe video standard from the pull-down menu.This must be done for Video and S-Video respectively.Page2Selecting Noise Reduction LevelSelect one of the three levels for reducing video noise: Off, Low, orHigh.NOTE: The lower the Noise Reduction level, the better the image quality byway of higher video bandwidth.Enabling Auto Adjust [Auto Adjust]When “Auto Adjust” is set to “On”, the projector automatically deter-mines the best resolution for the current RGB input signal to projectan image using NEC’s Advanced AccuBlend Intelligent Pixel Blend-ing Technology.The image can be automatically adjusted for position and stability;“Horizontal Position”, “Vertical Position”, “Clock” and “Phase”.On .................. Automatically adjusts image “Horizontal Position”,“Vertical Position”, “Clock” and “Phase”.Off .................. User can adjust the image display functions (“Hori-zontal Position”, “Vertical Position”, “Clock” and“Phase”) manually.Adjusting Position/Clock (when Auto Adjust is off)This allows you to manually adjust the image horizontally and verti-cally, and adjust Clock and Phase.Adjusts the image location horizontally and vertically.This adjustment is made automatically when the Auto Adjust is turnedon.Use this item with the “Auto Adjust off” to fine tune the computerimage or to remove any vertical banding that might appear. This func-tion adjusts the clock frequencies that eliminate the horizontal band-ing in the image. This adjustment may be necessary when you con-nect your computer for the first time. This adjustment is made auto-matically when the Auto Adjust is turned on.Use this item to adjust the clock phase or to reduce video noise, dotinterference or cross talk. (This is evident when part of your imageappears to be shimmering.)Use “Phase” only after the “Clock” is complete.This adjustment is made automatically when the Auto Adjust is turnedon.InformationDisplays the status of the current signal and lamp usage. This item hasthree pages. The information included is as follows:[Page 1]Source IndexHorizontal FrequencyVertical FrequencySync Polarity[Page 2]Signal TypeVideo TypeSync TypeInterlace[Page 3]Remaining Lamp Time (%)*Lamp Hour Meter (H)Filter UsageProjector Usage* The progress indicator shows thepercentage of remaining bulb life.The value informs you of theamount of lamp usage. When theremaining lamp time reaches 0,the Remaining Lamp Time bar in-dicator changes from 0% to 100Hours and starts counting down.If the remaining lamp time reaches0 hours, the projector will not turnon regardless of whether the lampmode is set to Normal or Eco.
|
