NEC WT600 - XGA DLP Projector User Manual

Also see for WT600 Series: Supplementary guide Command guide Command guide Control commands Compatibility chart

Contents

NEC WT600 - XGA DLP Projector User Manual Manual pdf 14 page image

1-64. LEDFlashes when any button is pressed.5. POWER ON ButtonWhen the main power is on, you can use this button to turnyour projector on.NOTE: To turn on the projector, press and hold the POWER ON but-ton for a minimum of two seconds.1-3. Part Names of the Remote ControlNOTE: If you are using a Macintosh computer, you can click eitherthe right-click or left-click button to activate the mouse.OFFVIDEOAUTO ADJ.RGB VIEWERLASERONPOWERSELECT2 131. Infrared TransmitterDirect the remote control toward the remote sensor on theprojector cabinet.2. LASER PointerBeams a laser light when the LASER button is pressed.3. Remote JackConnect your remote control cable here for wired operation.MENUPJASPECTOFFVIDEOAUTO ADJ.RGB VIEWERLASERON3D REFORMHELP POINTERVOLUME MAGNIFYZOOMPIC-MUTESLIDEFOLDERSLIDELISTEN T E RCANCELPOWERSELECTFREEZEFOCUS16211922272829172023252624151412111097 856418136. POWER OFF ButtonYou can use this button to turn your projector off.NOTE: To turn off the projector, press and hold the POWER OFF but-ton for a minimum of two seconds.7. VIDEO ButtonPress this button to toggle between Video and S-Video in-puts.8. RGB ButtonPress this button to select RGB, DVI (DIGITAL) or DVI (ANA-LOG) inputs. Each time this button is pressed, the input sourcewill change as follows:RGB → DVI (DIGITAL) → DVI (ANALOG) → RGB → ...9. VIEWER ButtonPress this button to select the Viewer source.10. AUTO ADJ. ButtonUse this button to adjust an RGB source for an optimal pic-ture.11. LASER ButtonPress and hold this button to activate the laser pointer. Whenlit, you can use the laser to draw your audience's attention toa red dot that you can place on any object.12. MENU ButtonDisplays the menu for various settings and adjustments.13. SELECT (Mouse) ButtonWhen you are in the Computer mode, these buttons work asa computer mouse.When you are in the Projector mode, which is indicated bylighting the PJ button. See page 4-1. : Use these buttons to select the menu of the item youwish to adjust. : Use these buttons to change the level of a selected menuitem. A press of the button executes the selection.When the pointer is displayed, these buttons movethe pointer.When the pointer is not displayed, these buttons arefor adjusting the image.14. ENTER (Left Click) ButtonWhen you are in the Computer mode, this button works asthe mouse left button. When this button is pressed and heldfor a minimum of two seconds, the drag mode is set. Whenyou are in the Projector mode, which is indicated by lightingthe PJ button: Use this button to enter your menu selection. Itworks the same way as the ENTER button on the cabinet.See page 4-1 for the Computer mode.1. Introduction