NEC WT600 - XGA DLP Projector User Manual

Also see for WT600 Series: Supplementary guide Command guide Command guide Control commands Compatibility chart

Contents

NEC WT600 - XGA DLP Projector User Manual Manual pdf 16 page image

1-830°30°30°30°Battery Installation1. Press the catch and remove the battery cover.2. Remove both old batteries and install new ones (AA). Ensurethat you have the batteries' polarity (+/-) aligned correctly.3. Slip the cover back over the batteries until it snaps into place.Do not mix different types of batteries or new and old batter-ies.Note on Battery Installation:If you press and hold the SELECT button while install-ing new batteries, the remote control may fail to work properly.Should this happen, remove the batteries and then install themagain without touching the SELECT button.Remote Control Precautions• Handle the remote control carefully.• If the remote control gets wet, wipe it dry immediately.• Avoid excessive heat and humidity.• If you will not be using the remote control for a long time,remove the batteries.• Do not place the batteries upside down.• Do not use new and old batteries together, or use differenttypes of batteries togetherOperating Range for Wireless Remote Control7m/22 feet7m/22 feetRemote controlRemote sensor on the projector cabinet• The infrared signal operates by line-of-sight up to a distanceof about 22 feet/7 m and within a 60-degree angle of the re-mote sensor on the projector cabinet.• The projector will not respond if there are objects betweenthe remote control and the sensor, or if strong light falls on thesensor. Weak batteries will also prevent the remote controlfrom properly operating the projector.Using the Remote Control in Wired OperationConnect one end of the supplied remote cable to the REMOTEmini jack and the other end to the remote jack on the remotecontrol.PJHELPPOINTERMAGNIFYSLIDEFOLDERSLIDELISTOFFVIDEOAUTO ADJ.RGB VIEWERLASERONPOWERSELECTASPECT FREEZE3D REFORMFOCUSVOLUMEZOOMPIC-MUTEPC CARDAUDIO INRVIDEO IN S-VIDEO IN DVI-I IN RGB IN RGB OUTDVI-I RGBAUDIO INUSB AUDIO OUTPCCONTROLREMOTEINL/MONOREMOTEIN1. IntroductionNOTE: When the remote cable is inserted into the REMOTE IN jack,the projector's status is changed from the Standby mode to the Idlemode.