NEC WT600 - XGA DLP Projector User Manual

Also see for WT600 Series: Supplementary guide Command guide Command guide Control commands Compatibility chart

Contents

NEC WT600 - XGA DLP Projector User Manual Manual pdf 20 page image

2-4PC CARDAUDIO INR L/MONOVIDEO IN S-VIDEO IN DVI-I IN RGB IN RGB OUTDVI-I RGBAUDIO INUSB AUDIO OUTPCCONTROLREMOTEINRGB IN1. Turn off the power to the projector and your video equipment.2. Use the NEC ADP-SC1 SCART adapter and a commercially available SCART cable to connect the RGB input of your projectorand a SCART output (RGB) of your video equipment.3. Turn on the power to the projector and your video equipment.4. Use the RGB button on the remote control to select the RGB input.5. Press the MENU button on the remote control to display the menu.6. From the Advanced menu, select [Projector Options] →[Setup] →[Page 3] →[Signal Select RGB] →[Scart].SCART is a standard European audio-visual connector for TVs, VCRs and DVD players. It is also referred to as Euro-connector.NOTE: The ADP-SC1 SCART adapter is obtainable from your NEC dealer in Europe. Contact your NEC dealer in Europe for more information.Using two RGB inputs simultaneouslyIf you need to use two RGB inputs simultaneously, connect the supplied DVI-A to VGA cable as shown below.Video equipment such as DVD playerProjectorADP-SC1Commercially available SCART cableFemaleTo RGB INTo connect SCART output (RGB)Before connections: An exclusive SCART adapter (ADP-SC1) and a commercially available SCART cable are required for thisconnection.NOTE: Audio signal is not available for this connection.2. Installation and ConnectionsPC CARDAUDIO INR L/MONOVIDEO IN S-VIDEO IN DVI-I IN RGB IN RGB OUTDVI-I RGBAUDIO INUSB AUDIO OUTPCCONTROLREMOTEINDVI-I IN RGB INRGB signal cable(supplied)IBM PC or Compatibles (Desktoptype) or Macintosh (Desktop type)DVI-A to VGA cable(supplied)IBM PC or Compatibles (Notebook type)or Macintosh (Notebook type)