2. Use the Left/Right Arrow buttons to display the 3/6: LINK GROUP parameter.3. Turn the Control encoder to select the desired Link group 1–8 for that pad or chooseNONE (default setting) to remove the pad from its current Link group.4. Press the Right Arrow button to display the 4/6: LINK MODE parameter.5. Turn the Control encoder to select the desired Link mode from MASTER (default setting)or SLAVE for that pad.6. Release PAD MODE (or press it again if you pinned the mode).5.2 Adjusting the Key, Choke, and Link Parameters for Multiple SoundsIn the software, if you select multiple Sounds with different Key, Choke and/or Link values, thecorresponding parameters in Pad view now display MULTI. On your controller in Pad Mode, thecorresponding parameters now display (MULTI).Moreover, you can adjust these parameters for the selected Sounds as described below.For general information on the Pad view of the software, the Pad Mode on your control-ler, and the Key, Choke, and Link parameters, please refer to section 5.1 “AdjustingYour Pads” in the MASCHINE 2.0 Manual.Adjusting the Key Parameter for Multiple Sounds with different Key Values► Click and drag the MULTI label next to Key to transpose the base key of all selectedSounds. While dragging, the field displays a +/-x value indicating the transposition thatwill apply to all Sounds as you release the mouse button.Playing on Your ControllerAdjusting the Key, Choke, and Link Parameters for Multiple SoundsMASCHINE MIKRO - Manual - 222
