Parameter DescriptionEND Adjusts the end point of the selected Slice. Note that moving the endpoint of a Slice does not simultaneously move the start point of thenext Slice — in opposition to adjusting the START parameter (seeabove).F2 and F3ADD (F2) Adds another Slice according to the current slicing settings.REMOVE (F3) Removes the start border of the selected Slice, thereby joining thisSlice with the previous Slice.► After you have performed your Slice edits, confirm them by pressing F1 (EDIT) again toleave Slice Edit mode (EDIT turns off).14.4.5 Applying the SlicingOnce you are satisfied with the proposed and/or manually adjusted Slices (see section↑14.4.2, Adjusting the Slicing Settings), you can apply the slicing in order to actually cut theoriginal Sample and create these Slices. This is done via the three elements at the bottomright of the Slice page:Sampling and Sample MappingSlicing a SampleMASCHINE MIKRO - Manual - 799
