11.2.2 Step 2: Set Up a Sound to Receive the External InputWe describe here the procedure in Arrange view. You can also do this in Mix view — seesection ↑8.1.1, Sending External Audio to Sounds.→ Now the external audio is routed to your Sound! You can adjust the level of the incomingsignal via the Gain knob.You will find a detailed reference of the Audio page of the Sounds’ Input properties insection ↑8.1.1, Sending External Audio to Sounds.On your controller:1. Press ENTER to enter Control mode.2. Press F3 to select the SOUND tab.3. Press GROUP + the pad 9–16 corresponding to the Group containing the empty Soundyou want to use. If the Group in question is in another bank, before you select the Groupyou first need to press GROUP + the Left or Right Arrow button below the display toswitch to the Group bank containing that Group.4. Press SELECT + the unlit pad of the empty Sound you want to use (or simply hit its unlitpad if pads are in Group mode).5. Press NAV + F2 (CHNL.) to show the Channel properties of the selected Sound.6. While holding NAV, turn the Control encoder at full left or simply press pad 13 to selectthe Input properties for that Sound.Using EffectsApplying Effects to External AudioMASCHINE MIKRO - Manual - 587
