→ The next time you select a new Scene or group of Scenes for looping, the new loop willstart from the beginning of the first Scene (Retrigger enabled) or from the same positionas where it left the current Scene (Retrigger disabled).13.5 Triggering Scenes via MIDI (MASCHINE Plug-in Only)If MASCHINE is running as a plug-in in a host environment, you can trigger and changeScenes using MIDI Note or MIDI Program Change messages sent from your host to the MA-SCHINE plug-in.When this feature is enabled, MIDI notes or Program Change messages are linked to the first128 Scenes slots MASCHINE’s Scene Manager (i.e. the Scene slots of the first 8 Scenebanks), whether they are empty or not:Scene Slot MIDI Note Number Program Change Number1 0 12 1 23 2 3… … …128 127 128MIDI Note numbers: Host applications use various conventions to name MIDI notes. Forexample, in MASCHINE, MIDI note number 0 is referred to as C-2 and MIDI note num-ber 60 (middle C) as C3. Please refer to the documentation of your host to know whichconvention is used.Program Change numbers: Some host applications send Program Change numbers in therange [0–127] instead of [1–128]. In that case, the PC number 0 will trigger Scene slot1, PC 1 will trigger Scene slot 2, etc. Please refer to the documentation of your host toknow in which range it sends Program Change numbers.To enable or disable the Scene MIDI Change feature, do the following:Creating a Song Using ScenesTriggering Scenes via MIDI (MASCHINE Plug-in Only)MASCHINE MIKRO - Manual - 750
