21-1Wyse Emulations21Wyse EmulationsThis chapter describes features of the Wyse WY-50, WY-50+ andWY-60 terminal emulations.IntroductionThe emulation of the Wyse WY-50, WY-50+ or WY-60 terminal is entered bydisplaying the Emulation Settings dialog box from the Settings menu and setting theAlpha Emulation option to Wyse 50, Wyse 50+ or Wyse 60. TeemTalk also supportsthe Wyse emulations of the TeleVideo 910+, 920 and 925, ADDS Viewpoint A2, andHazeltine 1500 terminals, selectable via the same dialog box option.All the Wyse associated emulations are configured via the Wyse Settings dialog boxwhich is described in the Setup Menus chapter. Note that some settings may notapply to the particular emulation currently running. Selecting a setting that is notapplicable to the current emulation will cause TeemTalk to use the default setting forthat emulation when the dialog box is exited.Display FormatThe display is divided into three areas by default: the status line, the data area, and thelabel line.At the top of the screen is the status line which is used to display information relatingto the emulation and messages from the application. The following section describesthe status messages that can be displayed by the emulation.The data area is where data entered from the keyboard or the application is displayed.The data area is set to 24 lines by 80 columns by default.The label line is displayed at the bottom of the screen when the data area is set to 24or 42 lines. This is can be used to display messages or function key labels defined bythe host.
