8-7Setup MenusThe file for storing captured data may be selected either by clicking the pointer overthe filename in the Files list box then clicking the Ok button, or by clicking the pointerin the Selection text box, typing the directory path and name of the file, then clickingOk.The Filter text box enables you to select the directory for display in the Directorieslist box. Click the pointer in the text box, enter the name of the directory then click theFilter button to display all the files in that directory.Clicking the Ok button after specifying the name of the file will cause all data receivedfrom the host to be stored in that file until the Cancel Capture option is selected. Thecontents of this file can be played back later by selecting the Replay File... option.Replay File...This option is only available when TeemTalk has been started using the -debug com-mand line option or debugMode resource. It will display a dialog box similar to thatshown above to enable you to replay the contents of a file previously created by theCapture File... option, either to the emulation (default) or the host. The dialog box isused in the same way as described for the Capture File... option.Cancel CaptureThis option is only available when TeemTalk has been started using the -debug com-mand line option or debugMode resource. It will cause TeemTalk to stop capturingdata during a Capture File session.Cancel ReplayThis option is only available when TeemTalk has been started using the -debug com-mand line option or debugMode resource. It will cause TeemTalk to stop replayingthe contents of a capture file during a Replay File session.Printer Setup...This will display a menu that allows you to select one of two printer setup dialogboxes:Note: This option will not be available if the printerFile resourceor -pf command line option was used to specify printersettings when TeemTalk was loaded.The Text Printer Settings and Graphic Printer Settings dialog boxes are shown onthe next page.Both dialog boxes enable you to specify whether print data is sent to a device, file orUNIX printer.
