236WAN Commandsatmping vccn [segment |end-to-end ]Lets you check the ATM connection reachability and network connectivity. This commandsends five Operations, Administration, and Maintenance (OAM) loopback calls to the speci-fied vpi/vci destination. There is a five second total timeout interval.Use the segment argument to ping a neighbor switch.Use the end-to-end argument to ping a remote end node.reset dhcp client release [vcc-id ]Releases the DHCP lease the Netopia Gateway is currently using to acquire the IP settingsfor the specified DSL port. Thevcc-id identifier is an “index” letter in the range B-I, anddoes not directly map to the VCC in use. Enter the reset dhcp client releasecommand without the variable to see the letter assigned to each virtual circuit.reset dhcp client renew [vcc-id ]Releases the DHCP lease the Netopia Gateway is currently using to acquire the IP settingsfor the specified DSL port. Thevcc-id identifier is an “index” letter in the range B-I, anddoes not directly map to the VCC in use. Enter the reset dhcp client releasewithout the variable to see the letter assigned to each virtual circuit.reset dslResets any open DSL connection.reset pppvccnResets the point-to-point connection over the specified virtual circuit. This command onlyapplies to virtual circuits that use PPP framing.show atm [all]Displays ATM statistics for the Netopia Gateway. The optional all argument displays amore detailed set of ATM statistics.
