283CONFIG CommandsSNMP Notify Type SettingsSNMP Notify Type is supported beginning with Firmware Version 7.4.2.set snmp notify type [ v1-trap | v2-trap | inform ]Sets the type of SNMP notifications that the system will generate:• v1-trap – This selection will generate notifications containing an SNMPv1 Trap ProtocolData Unit (PDU)• v2-trap – This selection will generate notifications containing an SNMPv2 Trap PDU• inform – This selection will generate notifications containing an SNMPv2 InformRe-quest PDU.System SettingsYou can configure system settings to assign a name to your Netopia Gateway and to spec-ify what types of messages you want the diagnostic log to record.set system namenameSpecifies the name of your Netopia Gateway. Each Netopia Gateway is assigned a name aspart of its factory initialization. The default name for a Netopia Gateway consists of theword “Netopia-3000/XXX” where “XXX” is the serial number of the device; for example,Netopia-3000/9437188. A system name can be 1 – 255 characters long. Once you haveassigned a name to your Netopia Gateway, you can enter that name in the Address text fieldof your browser to open a connection to your Netopia Gateway.☛ NOTE:Some broadband cable-oriented Service Providers use the System Name asan important identification and support parameter. If your Gateway is part ofthis type of network, do NOT alter the System Name unless specificallyinstructed by your Service Provider.
