WPA security settingsSelect WPA/WPA2 as the WLAN security mode.Select WLAN security settings and from the following:• WPA/WPA2 — Select EAP (ExtensibleAuthentication Protocol) or Pre-shared key (asecret key used for device identification).• EAP plug-in settings — If you select WPA/WPA2 > EAP, select which EAP plug-ins defined inyour device to use with the access point.• Pre-shared key — If you select WPA/WPA2 >Pre-shared key, enter the shared private key thatidentifies your device to the WLAN to which youconnect.• WPA2 only mode — To allow both TKIP and AES(Advanced Encryption Standard) encryption, selectOff. To allow AES only, select OnWireless LAN pluginsSelect Menu > Tools > Settings > Connection >Access points.The EAP (extensible authentication protocol) plug-insare used in wireless networks to authenticate wirelessdevices and authentication servers, and the differentEAP plug-ins make possible the use of various EAPmethods (network service).You can view the EAP plug-ins currently installed inyour device (network service).EAP plug-ins1. To define the EAP plug-in settings, select Options >New access point and define an access point thatuses WLAN as a data bearer.2. Select 802.1x or WPA/WPA2 as the security mode.3. Select WLAN security settings > WPA/WPA2 >EAP > EAP plug-in settings.Use EAP plug-insTo use an EAP plug-in when you connect to a WLANusing the access point, select the desired plug-in andOptions > Enable. The EAP plug-ins enabled for usewith this access point have a check mark next to them.To not use a plug-in, select Options > Disable.To edit the EAP plug-in settings, select Options >Edit.To change the priority of the EAP plug-in settings, selectOptions > Raise priority to attempt to use the plug-in before other plug-ins when connecting to thenetwork with the access point, or Options > Lowerpriority to use this plug-in for network authenticationafter attempting to use other plug-ins.See the device help for more information on EAPplugins.Session initiation protocol(SIP) settingsSelect Menu > Tools > Settings > Connection >SIP settings.120 Settings
