MN700004 Rev 01 aPrefaceThis guide provides the required information to setup and configure the ESB26 switch,firmware version 3.3.0. It is intended for network administrators who are responsible forinstalling and setting up network equipment. It assumes a basic working knowledge of thefollowing:• Local area networks (LANs)• Ethernet concepts• Ethernet switching and bridging concepts• Routing concepts• Internet Protocol (IP) conceptsIf the information in the Release Notes that are shipped with your unit differs from theinformation in this guide, follow the Release Notes.Conventions Used in This GuideThe syntax of CLI command lines, explained in "Basic CLI Operating Conventions" and thefurther topics and discussed throughout this guide, is represented by the following generalformat:device-name>keyword(s) [parameter(s)] ... [keyword(s)] [parameter(s)]ORdevice-name[ (config ...)]#keyword(s) [parameter(s)]... [keyword(s)] [parameter(s)]where:• The angle bracket (>) is the CLI prompt symbol in View mode.• The pound symbol (#) is the CLI prompt symbol in all other modes.• The left part, up to and including the prompt symbol represents the command promptdisplayed by the computer. In this part:device-name stands for the name of the switch (e.g. ESB26).The optional expression “(config)” or “(cfg ...)” – including the parentheses –appears on the screen exactly as in the manual.The part following the prompt symbol represents the users command. In this
