28MAINTENANCERegular maintenance is important for optimalperformance and to reduce wear. Inspect and properlytighten all parts each time the studio cycle is used.Replace any worn parts immediately.To clean the studio cycle, use a damp cloth and a smallamount of mild soap. IMPORTANT: To avoid damageto the console, keep liquids away from the consoleand keep the console out of direct sunlight.CONSOLE TROUBLESHOOTINGIf the console does not turn on, make sure that thepower adapter is fully plugged in.If a replacement power adapter is needed, call thetelephone number on the cover of this manual.IMPORTANT: To avoid damaging the console, useonly a manufacturer-supplied regulated poweradapter.If you are having problems connecting the consoleto a wireless network or if you are having problemswith your iFit account or iFit workouts, go tosupport.iFit.com.If the Console (10) does not stay in place when it ismoved to the desired position, tighten the indicated M8Locknut (99) slightly until the Console stays in place.If the console does not bootup properly, or if the con-sole freezes and does notrespond, reset the consoleto the factory default set-tings. IMPORTANT: Doingthis will erase all custom settings you have madeto the console. Resetting the console requires twopeople. First, unplug the power adapter. Next, locatethe small reset opening (A) on the side or the back ofthe console. Using a bent paper clip, press and holdthe reset button inside the opening, and have a secondperson plug in the power adapter. Continue holding thereset button until the console turns on. When the resetoperation is complete, the console will turn off and thenturn back on. If it does not, unplug the power adapterand then plug it in again. Once the console turns on,check for firmware updates (see HOW TO CHANGECONSOLE SETTINGS on page 25). Note: It maytake a few minutes for the console to be ready for use.INCLINE SYSTEM TROUBLESHOOTINGIf the frame does not move to the correct incline level,see HOW TO CHANGE CONSOLE SETTINGS onpage 25 and calibrate the incline system.Note: When the studio cycle is declined or extremelyinclined, the range of resistance levels may decrease.1099MAINTENANCE AND TROUBLESHOOTINGA