NordicTrack S22i User Manual

Also see for Commercial S22i Studio Cycle: User manual User manual User manual User manual User manual

29HOW TO ADJUST THE LEFT CRANK ARMIf the Left Crank Arm (21) feels loose while you arepedaling, first loosen the two M6 x 25mm Screws (96).Then, follow the steps below. Note: If you have atorque wrench, tighten the Screws (15, 96) to the listedtorque specs. If you do not have a torque wrench, sim-ply tighten the Screws as firmly as you can.1. Tighten the M12 Crank Screw (15) to 7 Nm(5 ft-lbs).2. Tighten each M6 x 25mm Screw (96) to 20 Nm(15 ft-lbs). Then tighten each M6 x 25mm Screw asecond time to 20 Nm (15 ft-lbs) in the same order.3. Finally, tighten the M12 Crank Screw (15) to 50 Nm(37 ft-lbs).HOW TO ADJUST THE REED SWITCHIf the console does not display correct feedback, thereed switch should be adjusted.To adjust the reed switch, first unplug the poweradapter. Next, remove the three indicated #8 x 5/8"Screws (152) from the Right and Left Shields (30, 32).Then, carefully pull the tops of the Right and LeftShields (30, 32) apart a few inches.See the inset drawing. Slightly loosen the two indi-cated #8 x 1/2" Screws (57). Next, rotate the LeftCrank Arm (21) until a Pulley Magnet (137) is alignedwith the Reed Switch (115). Slide the Reed Switchslightly toward or away from the Pulley Magnet. Then,retighten the Screws.Plug in the power adapter and rotate the Left CrankArm (21) for a moment. Repeat these actions until theconsole displays correct feedback.When the reed switch is correctly adjusted, reattachthe Right and Left Shields (30, 32).96211596152303215215221115832113711557