Nortel 10 Installation And Reference Manual

Also see for BayStack 10: Safety instruction Release note Installation instructions

Contents

15Installation and Reference for the BayStack 10 Power Supply UnitChapter 1IntroductionThis chapter provides an overview of components in the BayStack 10 PowerSupply Unit (PSU). The BayStack 10 PSU has powerful, modular redundantpower supply (RPS) and uninterruptible power supply (UPS) functionality in asingle chassis. It provides scalable power redundancy and protection tolow-wattage networking equipment. The RPS modules fit into the rear of theBayStack 10 PSU chassis. The UPS and its associated battery pack module fit intothe front of the chassis.You can provide DC power to up to four different devices, using the power supplymodules in the RPS section of the BayStack 10 PSU. If the utility power source isinterrupted, the UPS battery provides continuous AC power to those same fourdevices. You can purchase and install the RPS and/or UPS components of theBayStack 10 PSU, depending on the power requirements of your devices.Explanation of symbols on labelsFigure 1 shows all the symbols found on the BayStack 10 PSU and its componentparts, and the following list provides the explanation. You may not use all thecomponents, so you may not see all the symbols listed.Warning: This is a Class A product. In a domestic environment, thisproduct may cause radio interference, in which case the user may berequired to take adequate measures.Book.book Page 15 Thursday, April 19, 2001 4:21 PM