Nortel 10 Installation And Reference Manual

Also see for BayStack 10: Safety instruction Release note Installation instructions

Contents

36 Chapter 1 Introduction208296-CInstalling the UPS and battery pack moduleYour BayStack 10 PSU chassis is shipped without the UPS or RPS installed. Ifyou have already installed the RPS controller module, you must remove it beforeinstalling the UPS module. Be sure to turn off power to the controller module byunplugging the power cable before you remove the RPS controller module.Table 4 displays the output voltage and current for each UPS module: the UPSmodule for North America and Japan, and the UPS module for Europe.To provide uninterruptible power to your equipment, you must install the UPS andits battery pack module into the BayStack 10 PSU. Figure 13 shows an illustrationof the battery pack module.Figure 13 Battery pack moduleTable 4 UPS output voltage and currentUPS for North America and JapanInput: 100/120 V AC, 12 A, 60 HzOutput: 100 V AC, 12 A, 60 Hz, 1200 VA, 1000 W, pf: 0.83120 V AC, 12 A, 60 Hz, 1400 VA, 1000 W, pf: 0.7UPS for EuropeInput: 230 V AC, 7 A, 50 HzOutput: 230 V AC, 7 A, 50 Hz, 1400 VA, 1000 W10056FABayStack 10 Power Supply UnitBook.book Page 36 Thursday, April 19, 2001 4:21 PM