Connecting the components35Figure 9: Cable routing tracks and mounting holes8. Wall-mount your phone (optional). Your IP Phone 1140E can bemounted either by: (method A) using the mounting holes on thebottom of the phone stand, or (method B) using a traditional-stylewall-mount box with RJ-45 connector and 15-cm (6-inch) RJ-45 cord(not provided).Complete steps 1-7, as needed, before you wall-mount your phone:Method A: Press the wall-mount lever, and pull the phone away fromthe stand, as shown in Figure 10. Using the stand cover (the part youremoved in step 1), mark the wall-mount holes by pressing the bottomof the stand cover firmly against the wall in the location where youwish to install the phone. Four small pins on the bottom of the standcover make marks on the wall. Use the marks as a guideline forinstalling the wall-mount screws (not provided). Install the screws sothat they protrude 3 mm (1/8 inch) from the wall, and then install thephone stand mounting holes over the screw heads as indicated inFigure 9 (Method A). You may need to remove the phone from thewall to adjust the lower screws. When the lower screws are snug,Method AMethod B
