Using the BayStack 350 Series 10/100 Autosense Switch2-10 893-00992-ERack MountingYou can install the BayStack 350 switch in most standard equipment racks. TheModel 350F and Model 350T require a single-unit (1u) rack space for installation.The Model 350F-HD requires a 1.5-unit (1.5u) rack space for installation.In most cases, you can install the switch in the rack with the mounting bracketsattached, as shown in Figure 2-5. However, because of variances in rack hardware(cagenuts), the switch may not fit between the rails. In this case, you can install theswitch by attaching the mounting brackets as shown in Figure 2-6.To install the BayStack 350 switch in an equipment rack, follow these steps:1. If rubber footpads are attached to the bottom of the switch, remove them.2. Depending on the width of your rack, use the standard or alternativemethod of attaching the mounting brackets (Figure 2-5 or Figure 2-6).3. Using a Phillips or crosshead screwdriver, attach a mounting bracket toeach side of the switch using the supplied screws (Figure 2-5 orFigure 2-6).Caution: When mounting this device in a rack, do not stack units directly ontop of one another in the rack. Each unit must be secured to the rack withappropriate mounting brackets. Mounting brackets are not designed to supportmultiple units.Note: If you use the alternative method of attaching the mounting brackets tothe switch, the switch front panel will extend 2.54 centimeters (1 inch) fromthe rack.
