Using the BayStack 650 Wireless LAN Access Point6-4 203282-BFail-over commands—Use these commands to configure/displayfail-over attributes.fov ether-link-detect {enable | disable}fov infrstr-ping {enable | disable}fov ping-target-addr <ip_addr>fov showGo to page 6-12Help commands—Use these commands to display command groupsand command syntax.helphelp <commmod_group>Go to page 6-11IAPP commands—Use these commands to configure/displayInter-Access Point Protocol (IAPP) attributes.iapp interval <num_sec>iapp multi-vendor {enable | disable}iapp showGo to page 6-14Logging commands—Use these commands to clear and to displayerror log.log clearlog showGo to page 6-15Logout command—Use this command to log out from Access Point.logoutMAC commands—Use these commands to configure/display wirelessMAC layer attributes.mac beacon-interval <num_tu>mac dtim-period <num_beacon_intervals>mac frag-threshold <num_octets>mac rts-threshold <num_bytes>mac showGo to page 6-16password command—Use this command to change passwordpassword <password>reboot command—Use this command to reboot an Access Point.rebootTable 6-1. CLI Command List (continued)
