Installing and Starting the AP Manager203282-B 4-7Configuring an Individual Access PointAfter the AP Manager software is loaded and the access point has been assignedan IP address, you should configure the access point. Access points “discovered”on the subnet are displayed in the Access Point dialog box (Figure 4-4).Note: It may take a few seconds for your access point to display.To configure the access point:1. Choose Configure > Access Point.The Access Points dialog box opens (Figure 4-4). A list of access pointsinstalled on the Ethernet segment will begin to list in the entry field.Figure 4-4. Access Points Dialog BoxNote: In normal operation, your access points is detected and then displayed inthe Access Points dialog box (Figure 4-4).
