Page 114 of 504 M2016S Secure Set553-3001-367 Standard 3.00 August 2005If a telephone must be returned to the factory, pack it in the appropriatecontainer to avoid damage during transit. Remember to include all loose parts(cords, handset, power unit, labels, and lenses) in the shipment.Installation and removal of M2016S Secure SetFollow the steps in Procedure 24 on page 114 to install the M2016S.Procedure 24Installing the M2016S telephone1 Complete the wiring and cross-connections (loop power) beforeconnecting the telephone to the TELADAPT connector. See Figure 22 onpage 115 and Figure 23 on page 116.2 Place the telephone upside down on a number of sheets of soft, cleanpaper on a solid, level work surface to prevent damage to movable keysand the telephone’s face.3 Connect the handset cord (5-conductor TELADAPT connectors) to thehandset and snap it into place.4 Connect the other end of the handset cord to the connector in the bottomcover of the telephone. Turn the smooth side of the handset cord up(away from the telephone bottom cover) before tucking it under therestraining tab to ensure that the telephone will sit level on the desk afterinstallation is complete.5 Connect the line cord to the telephone bottom cover. Route the cordthrough the channels.6 Turn the telephone right-side up and place it in the normal operatingposition.7 Print the directory number on the designation card. Using a paper clip,remove the number lens from the telephone. Insert the designation cardand snap the lens back into place.8 Designate the feature keys.9 Insert the line cord TELADAPT connector into the connecting block (jack)and snap it into place.10 Perform the self-test (see Procedure 25 on page 116) and acceptancetest procedures. See LD 31 in the Software Input/Output: Administration(553-3001-311).
