Page 484 of 504 Appendix E: M3110, M3310, and M3820 telephones553-3001-367 Standard 3.00 August 20054 Plug the headset TELADAPT connector into the socket on the base of thetelephone marked with a headset icon.5 Route the headset cord through the channels at the side of the telephone.6 Replace the footstand in the same position and tighten both screws (ifpreviously fitted).7 Place the telephone back on the desk in the normal operating position.8 Plug the line cord connector back into the connecting block.End of ProcedureTelephone PositionsYour Meridian telephone can be installed in three different positions - twodesktop positions and a wall-mount position. The two desktop positionsprovide two different angles for the telephone on the desktop. The telephoneis supplied in the steeper of the two positions. Follow Procedure 84 foradjustment to the shallow-angel position, and Procedure 85 on page 485 forwall mounting.Procedure 84Adjusting the telephone to thedesktop shallow-angle positionThe procedure to change to the more shallow angle is as follows:1 Unplug the line cord from the connecting block.2 Remove the handset and place the telephone upside down on top of alevel, solid work surface covered with soft material or paper to preventdamage to moveable keys and the telephone face.3 Remove the 2 screws from the telephone footstand (if fitted) to separatethe footstand from the telephone.4 Snap the footstand back into place using the alternate slots located closerto the back of the set and tighten the screws (if previously fitted).5 Place the telephone back on the desk in the normal operating position.6 Plug the line cord connector back into the connecting block.End of Procedure
