97 Programming the COMPANION 200COMPANION 200 Installation and Maintenance Guide P0725810 Issue 3.01. Enter Configuration programming.2. Press * or & until the display shows2.Miscellaneous.3. Press ^. The display shows Link Time: followed by thecurrently programmed link time.4. Press *. The display shows Host delay: followed bythe currently programmed Host delay.5. Press CHANGE to loop through the setting options until the Hostdelay you want is displayed.6. Record the programmed Host delay in the COMPANION 200Programming Record.7. To continue in Configuration programming, press %.Gain padGain pad sets the transmission loss and receiving gain between thehost switch and the Controller. The gain pad needed for your systemdepends on the loop length of the access lines from the host switchto the Controller.1. Enter Configuration programming.2. Press * or & until the display shows2.Miscellaneous.3. Press ^. The display shows Link Time followed by thecurrently programmed Link time.4. Press * or & until the display showsGain Pad.5. Press ^. The display shows the currently programmedgain pad (Short Loop or Long Loop).6. Press CHANGE to change the Gain Pad.7. To continue in Configuration programming, press %twice.Optional system settingsSystem LIDThe System LID setting allows you to program the System AccessLogical Identifier (System LID). The system uses this code toidentify itself to portables, and the portables use it to request servicefrom the system. The System LID must be a hexadecimal number(four characters composed of a combination of the digits 0 to 9 and
