Programming the COMPANION 200 100P0725810 Issue 3.0 COMPANION 200 Installation and Maintenance Guidecan adapt to these changes and provide optimum performance. Allactive calls will be dropped when Data Re-evaluation begins. Tominimize the effects of Data Re-evaluation on the system, you canschedule it to run at a time of your choice.Please be aware that:• If the system detects the need for Data Re-evaluation, you will seeRe Eval Required on the Administration Terminal.• Approximate run times for Data Re-evaluation are shown in thePowering up section.• If a Base Station is removed or added while Data Re-evaluationis running, the re-evaluation procedure will take twice as long tocomplete.Running Data Re-evaluation1. Enter Configuration programming.2. Press * or & until the display shows3. Radio Data.3. Press ^. The display shows Re-Evaluation.4. Press ^. The display shows Re-Eval status.5. Press ^. The display shows Re-Eval required (theCOMPANION 200 system has detected a need for Data Re-evaluation), or Re-Eval not req. (the COMPANION 200system did not detect the need for Data Re-evaluation), or Re-Eval in prog. (the COMPANION 200 system is currentlyrunning Data Re-evaluation).6. Press CONTINUE. The display shows Re-Evaluate now?! Data Re-evaluation disables the COMPANION 200system.All active calls will be dropped when Data Re-evaluation begins.! Skipped or delayed Data Re-evaluation.To avoid skipped or delayed Data Re-evaluation ensure that thesystem's internal clock is set to the correct time. This is particularlyimportant after system start-up.
