99 Programming the COMPANION 200COMPANION 200 Installation and Maintenance Guide P0725810 Issue 3.0If the LID entered is not valid, the display shows LID notchanged. Go back to step 6 and repeat the process.11. Record the new System LID in the COMPANION 200Programming Record.12. To continue in Configuration programming, press %.Setting the antenna type for a radioYou must tell the system when an external antenna is installed orremoved. The setting options are internal or external antenna. Thedefault at system start up is internal. Always record the currentsetting in the COMPANION 200 Programming Record.A radio is identified by a five-digit number. For example, the number01121 means module 01, port 12 and radio 1.1. Enter Configuration programming.2. Press * or & until the display shows3. Radio Data.3. Press ^. The display shows Re-Evaluation.4. Press *. The display shows Radios.5. Press ^ . The display shows Show radio:_.6. Enter the five-digit radio number you wish to program. Thedisplay shows Cell Assignment.7. Press *. The display shows Antenna Type.8. Press ^. The display shows the radio number (nnnnn)followed by either internal or external, depending on thecurrent setting.9. Press CHANGE to change to the other type of antenna.10. Record the type of antenna programmed for the radio in theCOMPANION 200 Programming Record.11. Press * to change the setting of the next radio, or press% four times to continue in Configurationprogramming.Data Re-evaluationWhen the system parameters (such as new Base Stations or changein layout) have changed significantly (as determined by theCOMPANION 200 system or by the System Administrator), youmust run Data Re-evaluation so that the COMPANION 200 system
