56 ConfigurationVariable Valuepeer-ip Sets the peer IP address on thepoint-to-point link. The default is 0.0.0.0.pppfile Identifies the file to use for PPP initializationparameters.Procedure job aid: DTE-to-DCE straight-through pin assignmentsTable 3DTE-to-DCE straight-through pin assignmentsSwitch ModemSignal PinnumberDCE DB-9pin numberDCE DB-25pin numberRXD 2 2 3TXD 3 3 2DTR 4 4 20GND 5 5 7DSR 6 6 6RTS 7 7 4CTS 8 8 5Connecting a modem using the NNCLIConnect a modem to a Ethernet Routing Switch 8600 to establish aconnection with the switch. To connect a modem to an Ethernet RoutingSwitch you may need to set up the modem port using another type ofconnection, such as a terminal connection, to the NNCLI.You can access the NNCLI through a modem connection to the EthernetRouting Switch 8690SF, 8691SF/CPU, or 8692SF/CPU modules.ATTENTIONNortel recommends that you use the default settings for the modem port formost modem installations.Prerequisites• You need a DTE-to-DCE cable (straight or transmit cable) to connectthe Nortel Ethernet Routing Switch 8600 to the modem.• You must configure your client dial-up settings to establish theconnection to the modem.• You must log on to the Global Configuration mode in the NNCLI.Nortel Ethernet Routing Switch 8600Quick StartNN46205-310 02.01 Standard30 May 2008Copyright © 2008 Nortel Networks.