Chapter 5 IP telephones setup and configuration 55SRG50 Configuration GuideLocal mode indicationWhen an IP telephone is in local mode, a message is displayed on the phone to indicate the localmode state to the user. The default setting is Local Mode.To change local mode indication1 In Element Manager, navigate to Configuration > Resources > Telephony Resources.2 On the Modules panel, locate the Module type column and select the IP Sets row (see thefigure Telephony Resources panel, IP and App Sets on page 54).3 On the Details for Module subpanel, select the IP Terminal Global Settings tab.4 The Advertisement/Logo field specifies the message that provides local mode indication.Change as required.IP telephone codec and jitter settingsWhen the IP telephones are operating in local mode, codec and jitter settings are set on aphone-by-phone basis. Configure the settings to meet the requirements of the local SRGenvironment. They do not have to be the same as the main office settings (in contrast to the QoSsettings for the VoIP trunks; see QoS settings (codec, jitter buffer, and related items) on page 70).To enter codec and jitter settings for IP telephones in local mode1 In Element Manager, navigate to Configuration > Resources > Telephony Resources.2 On the Modules panel, locate the Module type column and select the IP Sets row (see thefigure Modules panel, IP & Application Sets on page 56).3 On the Details for Module subpanel, select the IP Terminal Global Settings tab.The fields related to QoS are on the right side of the panel.4 Enter the appropriate values.
