Chapter 5 IP telephones setup and configuration 61SRG50 Configuration GuideThe disadvantage of the second option is that the installer must configure the targetDN in two places: on the Active Sets panel and on the SRG-specific panels (theSRG-specific panels must be completed). The SRG looks at the SRG-specific panelsfirst. It goes to the Active Sets panel only if the VOIP Trunk Access Code has notbeen configured.Configuration settings for redirected phonesThe Telephony Device Installation Guide and the Networking Configuration Guide providedetailed instructions for configuring IP telephones. For IP telephones that are redirected to themain office call server, incorporate the settings shown in the table Configuration settings forredirected IP telephones on page 61.For more information, see CS 1000 considerations on page 33.Test Local ModeAn IP telephone operating in normal mode can be forced to redirect to the SRG. This allows thetelephone user, and system administrator, to test local mode operation without taking down theVoIP trunk to the main office.To activate Test Local Mode1 From the telephone dialpad, press the Services key .2 Press the Test Local Mode button.The telephone is now in Test Local Mode.Table 14 Configuration settings for redirected IP telephonesParameter CS 1000S1 IP SRG IP addressS1 Port 7300S1 Action 1S1 Retry Count 1S2 IP SRG IP addressS2 Port 7300S2 Action 1S2 Retry Count 1
