05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & ParametersAP 5.4 Gen II – AP 5.6AP 4.4 – AP 5.464-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)147Sensor adjust64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6 Parameter only appears in production mode. For detailed instructions sensor adjustment, please refer to the servicemanual, topic section "Service Electronics", paragraph "Settings".Sensor test64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6 The description of the sensor test can be found in the printer service manual,topic section „Service Electronics“, chapter Sensor test chapter Sensor test.The values displayed are for checking the sensors (sensor check) and canby adjusted by service personnel.Cutter test64-xx AP 4.4 AP 5.4 AP 5.6Makes it possible to test the cutter function without having to set the para-meter SYSTEM PARAMETER > Periph. device to „cutter“.Press Cut Key Triggers a cut, if a cutter is installed. Without a cutter nothing will happen.Matend adjustAP 4.4 AP 5.4These printer types are equipped with a single light sensor which is designedto detect both, punches and material end. The sensor must be able to detectthree different states:• No material• Only backing paper• Backing paper + label faceThe parameter SERVICE FUNCTION > Matend adjust can set the limit between beingrecognized as „only backing paper“ or as „material end“. For further information read the Service Manual, topic sectionService Electronics /, „Setting the material end sensor“.yy Level : xx Setting range: 0 to 255; Step width: 1; Default setting: 20Matend tolerance64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6Material end tolerance
