Nussbaum BT 610 Operating Instructions Manual
                                                                                                | |
Contents
| 
1 689 979 924N 26.11.07 575. Short instruction: Test with automaticalevaluation and documentation output5.1 Short instruction: Brake test on passenger car/truckwith automatical evaluation and documentation out-putThese short instructions are intended for users familiar withhandling brake test stands.Make sure that there are no persons in the test standarea!Danger to life for any persons in the test roller area!Observe the regulations for the prevention of acci-dents!In case of danger, press the„EMERGENCY STOP switch“ (13)!z Activate the test stand by means of the main switch (14).! Before inspecting a new vehicle, the measuring valuesmust be deleted using the key C (69).a. Drive vehicle slowly into the roller set.If the vehicle does not stand at right angles to the teststand, it will drift to the side!Danger to life for any persons in the test roller area!b. Select mode of operation„Automatik“ (Automatic mode) Press push-button „Automatik“ (12)or press A (68) and e (59) at the same time.The indicator light „Automatik“ (8) lights up.! Rollers start to move when the vehicle stands in the rollerset.or„Hand“ (manual operation mode) Press the key m (66). Press l (50) and e (59) t the same timefor the left-hand roller set. Press r (51) and e (59) at the same timefor the right-hand roller set.c. Make adjustments by „levelling out“.d. Secure wheels, outside the roller set by parking brake orwheel chocks.e. Brake „dry“ with brakes.f. Allocate the measuring values before the brake test.e.g.:Test of SBS - axle 1 Press the key a (64) orpress key a (64) 1 and E (60).Axle 1 of the SBS is set, the rolling friction is taken over intothe computer.g. Slowly increase brake force.Indication of brake forces and brake force differential.Automatic slip deactivation.Indicator light „Slip deactivation RH/LH“ (3) shows slipcause side.h. If the automatic slip deactivation is not obtained: Press key S (58).The drive motors are switched off.The brake force course is stored.In the automatic mode „Automatik“, the drive motors areswitched on again automatically after 4 seconds.If the brake pressure test is repeated, the first brake forcecourse is overwritten.! Drive off the vehicle from the test stand only in forwarddirection and when the test rollers are running!i. Test the next axle of the SBS (or PBS).j. Print standard log Press the key D (57) 1 and E (60). |
manualsdatabase
Your AI-powered manual search engine