Nussbaum BT 610 Operating Instructions Manual
                                                                                                | |
Contents
| 
84 26.11.07 1 689 979 924N15.2 Error weighing systemError code 10 30 *No signal weighing system left-hand sideCause:- Weighing system has been activated in the configurationmenu, but does not exist physically.- Wire breakage of the sensor line- Weighing system defective (unlikely, since weighing systemon the left-hand side consists of 4 sensors = compositesignal)Error code 10 31 *When switching on, no cal-check-function of the weighing sys-tem on the left-hand side.Cause:- Sensor line defective.- Cal-check-line interrupted (wire breakage)Error code 10 32 *Weighing system left-hand side has not been calibrated.Error code 10 35 *When switching on, zero point weighing system left-hand sideEEPROM compares to current weight. If the difference is toohigh, the error is displayed.Cause:- Weighing system not calibrated- Vehicle is on or in left-hand roller setError code 10 40 *No signal weighing sensor right-hand sideCause:- Weighing system has been activated in the configurationmenu, but does not exist physically.- Wire breakage of the sensor line- Weighing system right-hand side defective (unlikely, sinceweighing system on the right-hand side consists of 4 sensors= composite signal)Error code 10 41 *When switching on, no cal-check-function of the weighing sys-tem on the right-hand side.Cause:- Sensor line defective.- Cal-check-line interrupted (wire breakage)Error code 10 42 *Weighing system right-hand side has not been calibrated.Error code 10 45 *When switching on, zero point weighing system right-hand sideEEPROM compares to current weight. If the difference is toohigh, the error is displayed.Cause:- Weighing system not calibrated- Vehicle is on or in right-hand roller set15.3 Error inductive sensorError code 11 00 *No signal touch rollers speed left-hand sideCause:- Roller set has been activated in the configuration menu, butdoes not exist physically.- Inductive sensor defective- Sensor line defective- Distance between inductive sensor and feeler roller > 3 mmError code 11 05No signal touch rollers limit switch left-hand sideCause:- Roller set has been activated in the configuration menu, butdoes not exist physically.- Inductive sensor defective- Sensor line defective- Distance between inductive sensor and switching lug > 3mmError code 11 10 *No signal touch rollers speed right-hand sideCause:- Roller set has been activated in the configuration menu, butdoes not exist physically.- Inductive sensor defective- Sensor line defective- Distance between inductive sensor and feeler roller > 3 mmError code 11 15No signal touch rollers limit switch right-hand sideCause:- Roller set has been activated in the configuration menu, butdoes not exist physically.- Inductive sensor defective- Sensor line defective- Distance between inductive sensor and switching lug > 3mmError code 11 16The start-up locking protection for the roller sets has beentriggered 3 x in sequence.Cause:- Vehicle stands in roller set with the brake blocked or tighte-ned.- Defect at the touch roller inductive sensor: Inspect switchingdistance and wiring.Error code 11 40No signal speed sensor driving roll left-hand sideCause:- Cable breakError code 11 45No signal speed sensor driving roll right-hand sideCause:- Cable break |
manualsdatabase
Your AI-powered manual search engine