14-16 Key Operator ModeKey Operator ModeECM (Electronic Copy Monitor) Function Setting [4] (continued)How to Access the ECM Setting ModeKey Operator Mode Screen ECM Master Key Code ScreenECM Setting Menu Screen1 Press [ HELP ] to display the Help Screen, then touch Key Operator Mode.Enter a 4-digit key operator password, then touch OK to display the Key OperatorMode Screen. (See note 1.)If the key operator password is not valid, check with your service representative.2 Touch [4] E.C.M. function setting. The ECM Master Key Code Screen displays, if acode is required.3 Use the keypad on the touch screen to enter your 8-digit ECM master key code, thentouch OK to display the ECM Setting Menu Screen. (See note 2.)4 Select the desired ECM function, and make settings, as required.To exit the ECM mode, touch PREVIOUS SCREEN on ECM Setting Menu Screen.5 To exit the Key Operator mode, touch PREVIOUS SCREEN on the Key Operator ModeScreen to restore the Basic Screen.NOTES:1 If an invalid Key operator password is entered, continue by entering the valid 4-digit password.2 If an invalid ECM master key code is entered, continue by entering the valid 8-digit code. The ECMmaster key code can be set to less than 8 digits by the Memory switch setting of the Key operatorfunction.
