Key Operator Mode 14-37Key Operator ModeControl Panel Adjustment [10]Use this feature to check the LCD touch screen and realign the position of the touchsensor that may have shifted.Key Operator Mode Screen Control Panel Adjustment Screen1 Press [ HELP ] to display the Help Screen, then touch Key Operator Mode.Enter a 4-digit key operator password, then touch OK to display the Key OperatorMode Screen. (See note.)2 Touch [10] Control panel adjustment to display the Control Panel Adjustment Screen.3 Touch the “+” indication at the upper right corner, then lower left corner on thescreen. The present coordinates will be displayed in the message area of the screen.4 Check that the X coordinate and Y coordinate displayed in the first line of themessage area fall within the standard value displayed in the second line.5 Touch the CHECK BUTTONs at the upper left and lower right corners on the screen tocheck if the buzzer tone functions normally.6 If the coordinates fall out of the range of the standard value in step 4, or the buzzertone does not sound in step 5, repeat the adjustment procedure from 3 to 5.7 Press [0] of the control panel keypad to start writing the adjustment data.If other key operator setting changes are required, press [1] to restore the KeyOperator Mode Screen.8 If no further changes are required, touch PREVIOUS SCREEN to restore the BasicScreen to perform copying operations.NOTE: If an invalid Key operator password is entered, continue by entering the valid 4-digit password.
