Setting up network printing 4VarioLink 2221/2821/3621 4-31– Printer Number: Specify "255". (Set the number assigned to theprinter (0 to 254) or 255.)6 Restart this machine (turn the main power off, then on again).7 Use the NetWare server console to load MONITOR.NLM.8 Select the connection information and, in the active connectioncolumn, check that the created Pserver is connected.2 ReminderWhen turning the machine off, then on again with the main power switch,wait about 10 seconds to turn the machine on after turning it off. Themachine may not operate correctly if it is turned on immediately afterbeing turned off.For NetWare 5.x/6 Novell Distributed Print Service (NDPS)Before specifying settings for NDPS, check that the NDPS broker and NDPSmanager have been created and loaded.Also, before performing the following procedure, check that the TCP/IPprotocol has been set in the NetWare server, and check that the IP addresshas been set for this machine and that this machine is on.1 Log on to NetWare as an administrator from a client computer.2 Start up NWadmin.3 Right-click the organization or organizational unit container where youwill create the printer agent, and then click "NDPS Printer" on the"Create" sub-menu.4 In the "NDPS Printer Name" box, enter the printer name.5 In the "Printer Agent Source" column, select "Create a New PrinterAgent", and then click the [Create] button.6 Check the printer agent name, and then in the "NDPS Manager Name"box, browse through the NDPS manager names, and register one.7 In "Gateway Types", select "Novell Printer Gateway", and then registerit.
