Chapter 3 Using the Operator Panel3-49Message Language SelectionYou can select the language of the messages on the messagedisplay by following the procedure given below.Press the MENU key.Press the U or V key repeatedly until Others > ap-pears.Press the Z key.Press the U or V key repeatedly until >MSGLanguage appears. The default message language isEnglish.To change the language, press the ENTER key. Ablinking question mark (?) appears.Press the U key. The display cycles through theavailable selections in the following order (The Vkey cycles in the reverse order):EnglishFrancaisDeutschItalianoNederlandsEspanolPortuguesPress the ENTER key.Press the MENU key. The message display returns toReady.Automatic Form Feed Timeout SettingWhen the printer receives no data for a certain time, it timesout and releases the current interface: it prints whateverdata it has in its buffer and feeds out the page. You can ad-just the time-out time as follows:Press the MENU key.Press the U or V key repeatedly until Others > ap-pears.Press the Z key.Press the U or V key repeatedly until >Form FeedTime Out appears. The default setting is 30 seconds.Press the ENTER key. A blinking cursor (_) appears.Press the U or V key to increase or decrease the val-ue of the figure where the cursor is blinking and setthe desired time. The time can be set between 0 and495 seconds, in 5-second increments. (The printerdoes not timeout with the value set to 0.) You can usethe Z and Y keys to move the cursor right and left.Display the desired time and press the ENTER key.Press the MENU key. The message display returns toReady.Sleep Timer SettingThe printer has a sleep timer to conserve power when theprinter is not printing, processing, or receiving data. You canadjust the timer value, the length of time the printer waitsbefore entering sleeping mode in the absence of data.Press the MENU key.Press the U or V key repeatedly until Others > ap-pears.Press the Z key.Others >>MSG LanguageEnglish>MSG Language? English123456781Others >>Form FeedTime Out 030sec.>Form FeedTime Out 030sec.Others >2345678123