Chapter 3 Using the Operator Panel3-52Press the U or V key repeatedly until Others > ap-pears.Press the Z key.Press the U or V key repeatedly until > Buzzer ap-pears.Press the ENTER key. A blinking question mark (?)appears.Select On or Off using the U or V key.Press the ENTER key.Press the MENU key. The message display returns toReady.Auto Continue SettingWhen Auto Continue is enabled, the printer will automatical-ly print the next received data following a preset amount oftime passes after any one of the following errors occurs:Memory overflow Press GOPrint overrun Press GOKPDL error Press GOFile not found Press GORAM disk error Press GOMemoryCard err Press GOHard disk err Press GODuplex disabled Press GOAdd Staple Press GOChad box full Press GOIf one of the above errors is caused by someone on a networkwhere the printer is being shared, for example, data sent fromanother person will be printed after a preset amount of time.For setting the auto continue recovery time, see the next sec-tion.Press the MENU key.Press the U or V key repeatedly until Others > ap-pears.Press the Z key.Press the U or V key repeatedly until AutoContinue > appears.Press the ENTER key. A blinking question mark (?)appears.Select On or Off using the U or V key.Press the ENTER key.Press the MENU key. The message display returns toReady.Setting the Auto Continue Recovery TimeFollow the procedure given below to change the recoverytime for Auto Continue.Press the MENU key.Press the U or V key repeatedly until Others > ap-pears.Press the Z key.Press the U or V key repeatedly until AutoContinue Mode > appears.Press the Z key and display >>Auto ContinueTimer.Others >>BuzzerOn>Buzzer? On23456781Others >>Auto Continue >Mode Off>Auto ContinueMode ? OffOthers >>Auto Continue >Mode On234567812345