Oki Data CONFIDENTIAL45487001TH Rev.1 4-20 /4. Maintenance menusSelf-diagnosticmode layout(Overall)(1) Menu option display switchingThe level in a shaded area XXXXX can be displayed only fromanother one.Use the MENU or MENU button to display the menu optionshown in a non-shaded area XXXXX .LEVEL0- engine status displayEngine status displayEach voltage display category inprintingToner sensor monitorToner pulse count monitorRFID tag noise test monitorMotor control evaluation functionError codeDIAGNOSTIC MODE XX.XX.XX -MODESWITCH SCANMOTOR CLUTCH TESTTEST PRINTCONSUMABLE STATUSPRINTER STATUSFACTORY MODE SETSENSOR SETTINGLED HEAD DATANVRAM PARAMETERGRAPHIC PANEL ADJUSTBUZZER TESTPOWER ONNormal operation modeMENU and ONLINEheld down in combination(for three sec.)MENU , MENU , ENTERand BACK pressed incombinationNo buttons pressedMENU , MENU and HELP combination used until SystemMaintenance menu appears, and Diagnostic Mode selectedand ENTER pressedLEVEL0(1) Menu option display switchingHold down the BACK or ONLINE button or momentarily press the MENUor MENU button to display the option shown in a shaded area XXXX .Use the MENU or MENU button to display the menu option shown in anon-shaded area XXXX .Each voltage displaycategory during printingTransfer (TR) voltage(1)Transfer (TR) voltage(2)Charge (CH) voltageSupply (SB) voltageDevelopment (DB)voltageEnvironmental levelAfter elapsed timecorrectionBefore elapsed timecorrectionTransfer (TR) voltage(3)MENUMENUToner sensormonitorToner sensorstatus monitordisplayMENUMENUToner pulse count monitorEach color toner FULL/Number of LOW-pulsedetectionsHold down BACK(for two sec.)Hold down ONLINE(for two sec.)Error codeError code display, etc.Engine status displayHeater temperatureEnvironmental informationLow voltage humidityCH, DB setup table No.TR setup table No.TR off setup table No. , belt temperaturePress BACKMENUMENUMotor control evaluating functionsRegist Motor Constant-Speed TimerValue/ Environmental TemperatureFusing Motor Constant-Speed TimerValue/ Fusing Target TemperatureID Motor Constant-Speed Timer ValueMENURFID tag noise test monitorDisplay of number of noise detections/ Toner K errorMENU4.3.2 Self-diagnostic modeThis section describes LEVEL 0 and LEVEL 1.4.3.2.1 Operator panelThe following description on operating the self-diagnostic is provided, premised on thefollowing operator panel layout:NumericalkeypadCANCEL buttonENTERbuttonMENUbuttonATTENTION lamp(Amber)ONLINE lamp(Green)MENUbuttonBACKbuttonHELP buttonPower SavebuttonONLINEbutton
