Oki Data CONFIDENTIAL45487001TH Rev.1 4-31 /4. Maintenance menus4.3.2.7 Print counter displayThe print counter display is used for viewing print counter values.1. Enter the self-diagnostic mode and, until PRINTER STATUS appears, press theMENU or MENU button (the MENU button displays the next test option andthe MENU button displays the preceding test option). Then press the ENTERbutton.2. Pressing the MENU or MENU button displays each count printed (pressingthe ONLINE or CANCEL button is disabled).3. Press the BACK button to end the option (the state in step 1 is restored).Upper Display Lower Display Format Unit FunctionK-TOTALDRUM CNT******** IMAGES DEC Images Displays the total number ofrotation.TOTAL SHEETCNT******** PRINTS DEC Prints Displays the total number ofimages printed.(*1)*1 Tow counts apply to duplex print.4.3.2.8 Factory-Shipping mode switchingThe Factory-Shipping mode switching is used for switching from the Factory to Shippingmode.1. Enter the self-diagnostic mode and, until the following message appears, pressthe MENU or MENU button.FACTORY MODE SET2. Press the ENTER button. The following message appears. Press the MENU orMENU button until the option to set (refer to the table shown below) appearsFACTORY MODESHIPPING MODE *3. A setting for the option can be selected by pressing the ENTER button with theoption on the display.4. Hold down the ENTER button (for three seconds) with the setting on the display.The setting is stored in the EEPROM. The state in step 2 is restored.5. Repeat steps 2 through 4 when necessary.6. Press the BACK button to end the option (the state in step 1 is restored).Option Settings FunctionFACTORYMODEFACTORY MODE Establishes the Factory mode (a fuse-cutdisabling mode).SHIPPING MODE Deselects the Factory mode to enable the fuse-cut function.FUSE INTACTNote:****** is eitherINTACT orBLOWN.FUSE UNIT XXXXXX Displays the fuse status of the fuser.
