Oki Data CONFIDENTIAL45487001TH Rev.1 4-5 /4. Maintenance menus4.3 User maintenance menu functions4.3.1 Maintenance menu (for end-users)Some general menu categories on the operator panel of the printer serve as maintenancemenus (but are not system maintenance menus).The options available in the menus are as follows:Default setting in shade areaItem Settings FunctionsMenus SystemAdjustPower Save Time 1 minute2 minutes3 minutes4 minutes5 minutes10 minutes15 minutes30 minutes60 minutesSets time to wait for moving to Power Savemode.Moves to Power Save mode even duringan error.Sleep Time 1 minute2 minutes3 minutes4 minutes5 minutes10 minutes15 minutes30 minutes60 minutesSets the time to switch from Power Savemode to Sleep mode.The start point is the moment when theprinter goes into PowerSave.The printer will not enter sleep mode atthe following conditions.• Parallel is enabled.• Network is working on 1000Base-T Full/Half speed.• Error occurs.Auto Power Off Time 1 hour2 hours3 hours4 hours8 hours12 hours18 hours24 hoursSet the time to switch from Idle state to Offmode.Clearable Warning OnlineJobSets display deletion timing of clearablewarnings.PS: JOB onlyItem Settings FunctionsMenus SystemAdjustAuto Continue OnOffSets whether a printer is automaticallyrecovered or not when memory overflow/tray request occurs.(Wait time for recovery: 15 sec)Manual Timeout Off30 seconds60 secondsSets time to wait for paper to be fed inmanual feed.If paper is not fed within this period oftime, the job is canceled.Timeout Injob Off5 seconds10 seconds20 seconds30 seconds40 seconds50 seconds60 seconds90 seconds120 seconds150 seconds180 seconds210 seconds240 seconds270 seconds300 secondsSets time between stopping reception ofjob data and performing force printing.Does not perform printing and cancels thatjob instead in the case of PS.Timeout Local 0 seconds5 seconds~40 seconds~290 seconds295 seconds300 secondsTime of open of each port after end ofjob(The network is excluded. )Time of the port open indicates the timethat open the current port which receivingthe current job and so other port be ableto receive data.It increase /decreases in the step of 5
