Oki Data CONFIDENTIAL45487001TH Rev.1 4-32 /4. Maintenance menus4.3.2.9 Self-diagnostic function settingThe self-diagnostic function setting is used for enabling or disabling the error detection bysensors. The detection can be enabled or disabled temporarily for troubleshooting. Allowingfor setting engine operation options for which expert knowledge is required to be handled.This self-diagnostic should be used carefully. Be sure to restore the default settings of usedoptions of the self-diagnostic.1. Enter the self-diagnostic mode and, until the following message appears, pressthe MENU or MENU button.SENSOR SETTING2. Press the ENTER button. The following message appears. Press the MENU orMENU button until the option to set (refer to the table shown below) appears.TONER SENSORENABLE *3. The setting on the lower display can be selected by pressing the ENTER button.The MENU button displays the next setting and the MENU button displaysthe preceding setting.4. Hold down the ENTER button (for three seconds) with the desired setting on thedisplay. The setting is stored in the EEPROM. The state in step 2 is restored.5. Repeat steps 2 through 4 when necessary.6. Press the BACK button to end setting the option (except where not in step 4) (thestate in step 1 is restored).Option Set Settings Setting Operation FunctionTONERSENSORENABLE Enables detection. Enables or disables toner sensoroperation.DISABLE Disables detection.ID UNITCHECKENABLE Enable checking. Enables or disables image druminstallation checking.DISABLE Disables checking.DRUM OVERLIFESTOP Does not extendlife.Sets whether to enable or disableextending image drum life at the endof the life.CONTINUANCE Extends lifeOption Set Settings Setting Operation FunctionWR POINTREVTBL=**H±*.***mm00H~FFH A correction value. Adds a correction value for thedefault writing point.BOTTOMWRT POINTTBL=**H±*.***mm00H~FFH A tear-off positionvalue.Sets a tear-off length from thebottom edge of paper.Default is in hatched area.
